Why does my swamp cooler motor keeps shutting off?
Make certain that the electrical wiring and connections on your swamp cooler motor are secure and not overheating themselves or shorting out. Also, a bad switch in the swamp cooler motor or fuse can cause the motor to get hot and shut off.
Why does my swamp cooler pump keep burning out?
He said if the pad is not evenly wet, your water distributor might be clogged up. You don’t want excessive water; you just want enough water to keep the pads consistently wet,” said Garcia. Garcia said when your swamp gets overworked in this heat, a pump could burn out or a belt could get worn out and snap.
Why is my swamp cooler ticking?
Clicking Noises Could Be From Loose Parts When the float valve gets loose or loses its seal, it can move around and make loud clicking and clattering noises. This problem is easy to fix by replacing the valve if needed or just repositioning it.
What is the orange wire on a swamp cooler?
Typically a red wire operates the motor’s low speed and is connected to terminal “1,” a black wire operates the motor’s high speed and is connected to terminal “C” and an orange wire operates the pump and is connected to terminal “2.”
How many wires do I need for a swamp cooler?
Motors for regular household use are available with either one or two speeds. A two-speed motor will typically be prefitted with four short wires which must be connected to the swamp cooler control circuit and the 120-volt circuit.
How do you troubleshoot a swamp cooler?
First, check your fuse box or circuit breaker as the unit could have overloaded the circuit and caused a fuse to blow. Replace the fuse or reset the breaker to see if your cooler turns back on. Also, check the breaker inside the unit, if you have one, and reset it if it has been tripped.
Why did my cooler suddenly stop working?
Very often if your water cooler is not working, the problem can be traced to the power supply. So as a first step, check that it is properly plugged in at the wall and the mains power is turned on. If yours is a mains-fed water cooler, ensure the mains tap is turned on.
Why does my swamp cooler motor keep shutting off?
Your swamp cooler motor is designed to operate below a certain voltage limit. If the voltage is increased above that limit it will result in overheating of the motor. Eventually after achieving certain high temperature motor will shutdown to protect itself by the assistance of internal protection system.
How to take care of a swamp cooler?
Back to swamp cooler, make sure they know it is to be taken care of, not banged and bent, and belts and sheaves checked on a regular basis. Motor bearings will be shielded for life of the motor, up to you if you take the motor down and install premium C3 motor bearings, put in shielded or sealed, keeps the moisture out.
Why does my fan shut off when I turn it on?
Otherwise, as soon as the cooler blows air across the sensor, it cause it to shut off. Far more likely, is that you have a fan motor that is going bad (bearing or really out of balance) and it overheats, locking the fan up. If you are fairly handy and the motor is the problem, it is a reasonably easy fix.
What should I do if my water cooler stops working?
First, check your fuse box or circuit breaker as the unit could have overloaded the circuit and caused a fuse to blow. Replace the fuse or reset the breaker to see if your cooler turns back on. Also, check the breaker inside the unit, if you have one, and reset it if it has been tripped.