How do I reset my universal remote control?
Remove a battery from the remote and press a button to discharge the remote entirely. Reinsert the battery – the LED should blink twice. Press the digits 2 and 8 simultaneously within 6 seconds – the LED should blink twice.
Can you connect any remote to any TV?
Yes. Television remotes are generally identical to others of the same model. There are different programming models to link a particular remote to a particular television. Some even have no programmability (at one point), and just send out the codes for any television to pick up.
How do I find my universal remote code?
How to Find a Code for My Remote Control
- Look through the User’s Manual for your remote control to find the code section.
- Go to an website listing code, such as the Remote Code List (See References).
- Call the manufacture of your remote and ask whether it can tell you the codes you need.
What is the code for a universal remote?
4 digit codes for GE Universal remote controls (DVD Players)
| Brand | 4 Digit Code |
|---|---|
| KENWOOD | 0400 0429 |
| KISS | 0428 |
| KLH | 0430 0906 0386 |
| KONKA | 0410 0411 0412 0413 0905 |
How do you program an universal remote?
Programming a Zenith universal remote. Press and hold the “Program” button on the remote for three full seconds. The LED turns on when you have held the program button down long enough. Press the “TV” button on the remote to indicate you are programming a TV.
How do you program a DirecTV universal remote?
Here is how to Program a DIRECTV Remote Control. You can program your DIRECTV Universal Remote to control the following: TV, Audio components, Blu-ray player, DVD player, and VCR . If you have an HD DVR or HD receiver, follow these steps: Press MENU on your remote. Select Settings & Help.
How do you set up Philips Universal Remote?
Point the Philips remote at the device you want programmed, then press and hold the “Setup” or “Code Search” buttons on your Philips remote. Release the “Setup” or “Code Search” button when the red indicator light starts blinking. Press the device button for the device you’re programming with the remote.
How to program spectrum remote to TV?
– Turn on the television. – Hold the Spectrum remote control close enough to the cable box while facing it. – On the remote, simultaneously press the “CBL” and “OK/SELL” buttons. Hold them in place for a few seconds until an LED light appears. – Your remote is ready to programme once the light is turned on. Enter the necessary codes for your cable box’s brand and model at this stage. – The cable box will switch off immediately once you input the proper code. When this happens, click the “POWER” button on the remote to test it. – To save the code and complete the procedure, press the “CBL” button once again.