Why is my AC not working in my Ford Fusion?
The most common causes that hinders normal operation of air conditioning system on your Ford Fusion are dirty cabin air filter, refrigerant leak, dirty or clogged condenser, dirty or clogged evaporator, bad blower motor, defective compressor, faulty blend door actuator or any fault in the electrical system.
How do you know if your AC pressure switch is bad?
The most common symptom of a bad AC pressure switch is a faulty or intermittent air condition function. In most cases, you will notice this during hot days when there is not blowing any cold air through the vents.
Where is the low pressure switch located?
The low side service valve is located in the line that runs from the compressor through the evaporator (firewall) and up to the condensor on the low pressure (suction) side of the system.
How do I reset my Ford Fusion air conditioner?
Using the controls around the climate control module, press the climate control power button along with the defrost button at the same moment. Now, decompress the buttons, and push the climate control power button once more. This should fully reset the cc in Your vehicle.
How do you reset a Ford HVAC module?
With the doors closed locate the climate control power button on the center dash and depress it simultaneously with the Edge’s defrost button. Hold for a few seconds and release. Press the climate control power button one more time and the HVAC should be reset.
Where is the AC sensor located?
The thermostat sensor is located near the evaporator coils. These coils are inside your air conditioner unit. As the air is sucked through the return vents, the air passes by the sensor and the coils. As the air passes the sensor, it reads the temperature and compares that reading to the setting on your thermostat.
How do I know if my AC compressor relay is bad?
One of the most obvious signs that the AC relay may have a problem is that the compressor is not coming on at all. In most cases, when the AC is turned on you will be able to hear the compressor switch on. It will usually produce a familiar clicking noise from the clutch being activated.
Where is the AC compressor switch?
The AC pressure switch is a safety switch that is mounted on both the high and low sides of the air conditioning system. It monitors the pressure of the refrigerant on its respective side of the system.
Why is my a/C not working on my Ford Fusion?
I should start by saying there are many reasons why your car’s A/C can stop working. But on the Fusion, if the A/C compressor is not turning on, you will need to change the Evaporator Discharge Air Temperature Sensor. The sensor tells the computer what the air’s temperature is at the exit point of the evaporator.
Does the AC evaporator sensor on a 2012 Ford Fusion need replacing?
Workaround that avoids the replacement of the AC evaporator sensor from all Ford Fusions up to 2012. A problem that Ford should take care in guarantee considering the poor quality of the sensor used and because it is a recurring problem on several vehicles.
What to do if your Ford Focus AC is not working?
Ask your Ford dealer. Evap Temp Sensor Replacement – When the Evap temp sensor goes bad it will prevent the A/C compressor from turning on, this is a common problem in most Ford Focus, Fusion and also other models. Read reviews of repair shops in your area.
Why does my Ford air conditioner turn off when it gets cold?
The sensor tells the computer what the air’s temperature is at the exit point of the evaporator. When it senses that it’s cold, it turns off the compressor. Otherwise, the system would freeze. Well, sometimes these sensors short out and will not allow compressor operation. Ford is well aware that the sensors are faulty.